9/23/2023 0 Comments Dodge magnum plywoodThe problem with laser cutting plywood is not the type of wood making up the plys but the glue. I do some laser cutting, so I can offer a few observations. But much more expensive per sq-ft than what I've used so far.Īny comments or suggestions would be welcome! What kills the plywood is the glue and other "stuff" that goes into making it. Clean cuts, very minimal charing (if any, typically just a nice browning occurs). AND finding relatively flat stuff (so that it lays flat on the laser bed) has been a hassle.įrom what I've read online, hardwoods are the best for laser cutting. The problem is that the midwest stuff is $13 for a 12"x24" sheet, vs $3 for the same size. The Midwest products material came out great, but the 3 ply stuff charred real good on the edges. So far we've cut some from 1/8" plywood from Midwest products and some from a 3 ply 1/8" plywood from national Balsa. The problem is the type of wood to use that cuts the best and is the most cost effective (although at this stage I can forego the costs for the end result!). Does anyone have any experience getting parts laser cut? I have a number of parts that are going to be cut out of 1/8" thin plywood, and I have a source that will cut them for me. I thought I'd throw this out there and see what gets thrown back.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |